Vibration dampening tools—or silent tools as they are sometimes referred to—have been around for quite a while. Mold and die shops incorporate such tools to eliminate vibration issues associated with the long slender tools needed to machine the deep and narrow cavities of molds and dies.

Most shops apply silent tools to finish cut operations for generating smooth mold and die surfaces that require little, if any, secondary benchworking. But what these shops may not realize is that they can gain significant benefits by also using silent tools for roughing operations.

Silent tools, in particular dampened adapters, allow mold and die shops to run rough machining operations at faster cutter speeds and feeds, and take depths-of-cut that are frequently three times deeper than those possible with a comparable solid steel extended tooling assembly.

Additionally, today’s dampened adapters can work at much longer tool lengths and apply to wider ranges of materials—including stainless steels and titanium—compared to standard extended tooling assemblies.

When tools vibrate, they make noise, which is where the term silent tools originated. Dampened adapters counteract tool vibrations with passive internal systems that vibrate at different amplitudes than those being generated at the cutting edge of the tool.

Dampened adapters are an interface between machine tool spindles and cutting tool tips. The dampened adapter and cutting tool could be a one-piece design with the cutting tool integrated into the adapter, or it could be a system where cutting tools mount to the end of the adapter and are interchangeable.

Hollowed out chambers at the front of dampened adapters house what is known as the damper. Dampers are cylindrical-shaped heavy metal slugs surrounded by and floating in oil within the chamber. They have rubber grommets attached at each end, which in turn, are attached to springs attached to the edges of the chamber.

As standard tools start to cut, they begin to vibrate at particular amplitudes, and shops basically deal with them by reducing speeds and feeds. On the other hand, when these vibrations reach the dampening mechanism of a dampened adapter, the damper begins to move up and down vibrating at an opposite amplitude. This motion occurs in milliseconds and counteracts the vibration amplitude to completely eliminate any negative affects on workpiece surfaces.

Dampening mechanisms in silent tooling are passive systems that react to vibrations to control them. This is unlike active systems that involve the introduction of external mechanical or electrical forces/vibrations that help cancel out those generated by a cutting tool. Active systems are not internal and would involve some type of outside device.

Mold and die shops not using dampened adapters must build tools out to needed lengths. But to achieve fine surface finishes, these tools have to run at incredibly light cutting data, dramatically prolonging finishing operations and overall part cycle times.

It is recommended that shops already using or considering dampened adapters should match adapter to cutting tool. Specific tooling manufacturers design their adapters to run with their cutting tools. And while some shops will mix and match, the best possible cutting performance results from pairing adapter and tools from the same manufacturer.

In addition to mold and die milling applications, dampened adapters can be used for internal turning, boring and drilling. As with milling, these products work on overhangs beyond the limitation of solid steel and solid carbide shanks. They are easy to operate and are very flexible due to the wide variety of back-end and front-end couplings available.

Maintenance Tips for Dampened Adapters

At about 95 percent of the time, dampened adapters only fail due to tool crashes. Otherwise dampened tooling will last for many years of use. In fact, a lot of the systems manufactured in the 1980s are still in use today. To ensure silent tooling/dampened adapters always perform at their best, tooling manufacturers offer these six maintenance tips.

1.If the oil in a dampened adapter has become too viscous due to long storage or transportation in low temperatures, gently knock on the bar with a rubber hammer.

2.For optimum performance, clean all mating parts and lubricate with oil at least once a year. Lubricant should also be applied to the screws when needed.

3.Replace worn or exhausted screws and washers.

4.When assembling, ensure that the adapters are held correctly.

5.Always check the clamping when working with damping adapters and tooling tips.

6.Always use a torque wrench for correct screw tightening.