2011 abrasive abrasive abrasive abrasive standard meeting standardized work conference held in zheng. The 2011 national abrasive abrasive standardization work conference in 2011, May 17 to 19, held in zhengzhou city, henan province, the participants a total of more than 30 people, mainly including: the national abrasive abrasive standardization technical committee; In ordinary abrasive, abrasive and common silicon carbide special products, superhard materials and products, coated abrasive points with technical committee deputy secretary general of the above personnel. According to the national resin nets expert introduction, the abrasive abrasive standardization technical committee (hereinafter referred to as the "standard") the chairman of the committee, council of zhengzhou abrasive abrasive grinding, deputy director of institute of liumengyao senior engineer, presiding over the meeting, the state council secretary general standard abrasive abrasive quality supervision and inspection center ZhongYanZheng senior executive deputy director engineers to "for the industry group the ISO/TC29 / SC5 37 times abrasive abrasive international standardization meeting" relevant matters to do a detailed explanation; Standard council commission, standard commission secretariat WangWeiTao engineers national standardization management committee of the abrasive abrasive issued standard system of the project of the study of the process and the project content set. After a full review discussion, brainstorm, meeting to a vote of the delegation "ISO/TC29 / SC5 37 times abrasive abrasive international standardization conference" 19 standard project put forward concrete vote on one opinion.

The meeting agreed to the abrasive abrasive principle standard system of research reports and ask mark according to the review process of the secretariat of the council put forward the Suggestions and opinions, and the industry three association, perfect communication related content, and submit to report after the national standardization management committee accepted; The meeting adopted the "abrasive abrasive standard system KuangJiaTu/table" and "2011 2015 abrasive abrasive standard system revision of project planning. According to the national resin nets expert introduction, the delegation will take part in June 15, 2011 held in Stockholm, Sweden, "ISO/TC29 / SC5 37 times abrasive abrasive international standardization meeting". It's the industry in the 1980 s of cfna attended the abrasive abrasive international standardization meeting, in 1992, a visiting group Japan ordinary abrasive standard sand for manufacturing after talking, after nearly twenty years abrasives standardization of workers in important international exchange activities, is of great significance, marks the industry standardization to open the communication channels, both to study and absorbing foreign advanced standardization work experience, but also to show the publicity to the international and domestic abrasive abrasive industry in recent years the great development of achievement, make the world to listen to the voice from China, strive for more right for industry.